SUNLU Filament: PLA, PLA+ or Silk, and Which Line to Buy
Short answer Buy SUNLU PLA+ for parts that get used and dropped, plain SUNLU PLA for models and quick prototypes where cost…
Category: Filament
Print and bed temperatures, drying times, enclosure requirements, and how to choose between PLA, PETG, ABS, ASA and the filled variants.
3D Printer Resin: Standard, ABS-Like or Water-Washable, and What Each Is For
Short answer Start with a standard 405 nm resin for miniatures and detail, move to an ABS-like or tough resin the first…
TPU Printer Filament: Shore 95A Explained and How to Print Flexible Parts
Short answer For a first flexible filament buy TPU rated Shore 95A: it is soft enough for phone cases, gaskets and grips…
PETG 3D Printer Filament: Which One to Buy and How to Print It Clean
Short answer Buy PETG when a part must survive heat above 60 °C, outdoor use or repeated flexing: it is tougher than…
Best Filament for Outdoor Use: ASA, PETG or Polycarbonate, Compared Honestly
Short answer For anything that lives in sunlight, ASA is the filament to buy: UV stable, rain-proof and good to about 95…
Nylon Filament: PA6, PA12 or Carbon-Fibre Nylon, and Which Spool to Buy First
Short answer Buy a carbon-fibre nylon (PA6-CF or PA12-CF) as your first nylon: the fibres stop the warping that makes unfilled nylon…
PLA Filament: What Makes a Good Spool, and Why Most Print Problems Are Not the Filament
Short answer Any PLA with a stated diameter tolerance of ±0.03 mm from a maker that vacuum-seals the spool will print well…
Which 3D Printer Filament to Buy: Pick by the Part, Not the Brand
Short answer There is no best filament, only the right one for the part: PLA for models and prototypes, PLA+ for everyday…
Support Material for PLA: PETG Interfaces, PVA, and When Plain PLA Supports Are Enough
Short answer If you have a multi-material system, print PETG as the support interface under PLA: the two barely bond, so the…
Strongest 3D Printer Filament: Strength Is Three Different Things, and Which Material Wins Each
Short answer Decide which strength you need. For a part that must not snap when dropped, PETG or unfilled nylon. For a…