HMS 07FE-4500-0002-0001: Filament Cutter Sensor Fault
LayerWalker is a participant in the Amazon Services LLC Associates Program. We may earn a commission when you buy through links on our site, at no extra cost to you.
HMS 07FE-4500-0002-0001 means the filament cutter sensor is malfunctioning, and asks you to check whether the connector is properly plugged in. The machine is not claiming the sensor is dead: it is telling you the signal is not arriving and suggesting the likeliest reason.
A sensor that has been unplugged during a previous repair is more common than a sensor that has failed.
Where to buy
Understand what kind of switch it is
Most cutter position sensors are simple micro limit switches. A twelve-pack costs a few pounds and gives you a known-good part to compare behaviour against, which is far quicker than reasoning about it.
Open the cover without marking it
A nylon pry tool kit gets a snap-fit cover off without the gouges a screwdriver leaves. On a part you will open again, that matters more than it sounds.
Probe the contacts you can actually reach
A set of multimeter test leads with fine probes and alligator clips lets you hold continuity on two tiny pins while you work the mechanism with your other hand. Trying to do that with standard probes is how pins get bent.
Then check continuity while you move it
Clip across the switch and operate the handle. A switch that toggles cleanly is fine and the fault is in the loom; one that never changes is the part.
How HMS 07FE-4500-0002-0001 differs from a stuck handle
A handle that does not return is HMS 07FE-4500-0002-0003. This code is the sensing side, so the mechanism may be working perfectly.
When another sensor reports the same way
An open Hall circuit on the switching angle is HMS 07FE-8000-0001-0002. General order of work is in troubleshooting and the platform in the Bambu Lab H2D.
HMS 07FE-4500-0002-0001 FAQ
Can I print without the cutter?
Not with automatic material changes. Single material, often yes.
Why does the message say connector?
Because an unseated plug causes this far more often than a dead switch.
Will reseating clear the code?
If that was the cause, immediately.
How do I test it safely?
Power off, continuity across the switch, operate by hand.
Sensors in the AMS fail at the plug too. HMS 0700-3500-0001-0002 means the humidity sensor is disconnected, probably at the connector, and without it the AMS cannot judge when drying is finished.
LayerWalker
Print defect diagnosis, calibration procedures and parts that actually fit. Corrections welcome through the contact page.
