Creality Space Pi Filament Dryer: The Single and Four-Spool Units, and Which Materials They Reach
LayerWalker is a participant in the Amazon Services LLC Associates Program. We may earn a commission when you buy through links on our site, at no extra cost to you.
Creality’s Space Pi dryers are the budget units that reach the higher temperatures PETG, ABS and nylon need, and the four-spool Space Pi X4 with its 200 W heater is built to feed a CFS or AMS with dry filament. Buy the single-spool Space Pi for one printer and PETG; buy the X4 for a multi-material setup or for drying a week’s spools at once.
Creality’s dryers arrived after SUNLU’s and answered the main complaint about budget dryers: a temperature ceiling too low for anything but PLA. The Space Pi line runs hotter, has a fan, and the X4 version holds four spools with PTFE outlets that route into a multi-material unit. They are still budget hardware; the seals and hygrometers are basic. For the price they dry the materials that matter.
Where to buy
The units
- Space Pi single-spool. One spool, fan, timer, print-through holes, a ceiling high enough for PETG, ABS and ASA and most of the way to nylon.
- Space Pi X4. Four spools, 200 W PTC heater, four PTFE outlets. For a CFS, an AMS, or a farm. Slower to reach temperature with four cold spools inside; leave it a while.
What to check
- Maximum temperature against your materials: PLA 50 °C, PETG 65 °C, ABS 70 °C, nylon 80 °C and up. See the drying guide.
- Spool fit. Standard 1 kg spools; wide cardboard spools and 2 kg spools may not.
- Outlet fittings that accept your printer’s PTFE tube.
- Hygrometer reading, to know when a spool is done.
The dryers in the box
Creality’s Space Pi X4 is the four-spool unit; SUNLU’s S1 Plus is the fan-equipped single-spool alternative at a lower ceiling; the Comgrow dryer is the entry-level single-spool box. For one printer and PETG, S1 Plus or the single Space Pi; for a CFS or AMS, the X4.
Using it
- Dry a new spool 6 hours for PETG, 8 to 12 for nylon, before printing.
- Print from the dryer at a holding temperature 5 to 10 °C below drying temperature.
- Swap desiccant when the indicator changes.
- If a spool still strings after a full cycle, dry longer; four spools in the X4 take longer than one.
FAQ
Does the X4 dry nylon? It reaches the temperature; give it the full 12 hours.
Can I use Space Pi with a Bambu AMS? Yes; route the PTFE outlets to the AMS inlets.
Is it loud? The fan is audible; similar to a small PC fan.
LayerWalker
Print defect diagnosis, calibration procedures and parts that actually fit. Corrections welcome through the contact page.
